No Clean-Flux, water-based with added alcohol
Di-carboxylic acids, low VOC, halogen-free activated, with synthetic resin, rosin-free (WEEE/RoHS compliant)
Type ISO-9454: 2231 (2.2.3.A) // DIN EN 61190-1-1 (IEC: ORL0)
| Appearance: | clear, colourless liquid |
| Hazardous goods: | No |
| VOC: | 15 % |
| Solids content: | 2.0 wt.-% |
| Acid number: | 24 – 28 mg KOH/g |
| Halogen-free: | Yes |
| Resiny: | Yes |
| Density at 20 °C: | 0.9 – 1.0 g/ml |
| Activators: | di-carboxylic acids, resin |
| Solvents: | water with alcohol additive |
| Flash point: | hardly flammable |
| Available as concentrate: | No |
| Durability: | 12 months |
EO-Y-014A is universally suitable for wave and selective soldering of PCBs. It contains organic, halogen-free, rosin-free, activating additives in a combination specially tuned to the thermal requirements of the wave soldering process with leaded and lead-free solders. EO-Y-014A contains small amounts of special alcoholic additives for stabilization and improved drying times compared to conventional water-based fluxes.
The solids content is 2.0 wt.-%.
Instructions for use:
This flux must be applied by spraying. After application, it is advisable to dry the flux in order to transform the liquid into fusible phase which favours the soldering operation.
Foamfluxing: Not recommended
Sprayfluxing: If possible, try at first a quantity of 20 – 30 ml/min. and observe the distribution of the flux. After that, correct to the quantity. Air-pressure: 18 – 22 l/min.
Preheating: For “simple” PCBs a preheating temperature of 80 – 110 °C is recommended, for “more complex” PCBs of 100 – 130 °C on the top side of the PCB. The use can be made both in leaded and lead-free solder systems.
