Flux, alcohol-based
Di-carboxylic acids, synthetic resin complex, halogenide-free (WEEE/RoHS compliant) [OSP compatible]
Type ISO-9454: 1231 // DIN EN 61190-1-1: L0 (REL0)
| Appearance/smell: | colourless pale yellow, clear liquid |
| Hazardous goods: | Yes |
| Solids content: | 2.0 wt.-% |
| Acid number: | 14 – 16 mg KOH/g |
| Halogenide-free: | Yes |
| Resinous: | Yes |
| Available as concentrate: | No |
| Density at 20 °C: | 0.793 (+/- 0.003) g/ml |
| Flash point: | 12 °C |
| Durability: | 12 months |
This flux is very versatile in use and OSP-compatible. Good results have been achieved both with manual, wave and selective soldering. The general rule is to basically apply as little flux as possible, is also applicable for this product.
Spray fluxing: With the dosing option quantify of flux, first set to 30 – 40 ml/min., observe the even distribution of flux on the circuit board (if necessary test with heat-sensitive paper) and then adjust to the optimal quantity.
Preheating: With “simple” circuit boards a preheating temperature of 80 – 110 °C is recommended on the top side of the circuit board, with “more complex” boards a temperature of 100 – 130 °C. It can be used both in solder systems containing lead as well as lead-free solder systems.
