No Clean-Flux, alcohol-based
Resin-carboxylic and di-carboxylic acid complex, halogenide-free (WEEE/RoHS compliant)
Type ISO-9454: 1231 (1.2.3.A) // DIN EN-61190-1-1 (acc. J-STD-004) (IEC: REL0)
| Appearance/smell: | transparent to yellowish liquid |
| Hazardous goods: | Yes |
| Solids content: | 2.0 wt.-% |
| Acid number: | 5 – 7 mg KOH/g |
| Halogenide-free: | Yes |
| Resinous: | Yes |
| Available as concentrate: | No |
| Density at 20 °C: | 0.793 (+/- 0.003) g/ml |
| Flash point: | 12 °C |
| Durability: | 12 months |
| Storage (recommendation): | store at 5 – 25 °C, dry, sealed |
EO-B-023A is universally suitable for wave, selective and hand soldering of PCBs and complies with specification DIN-EN 61190-1-1: L0. Accordingly, it contains organic, halogen-free activating additives with resin in a combination specially tuned to the thermal requirements of the soldering processes. EO-B-023A can be applied by brushing, spraying, dipping etc. The solids content is 2 wt.-%. EO-B-023A is totally free from corrosion action. Additional information on the ingredients (hazardous substances), safe handling, storage, transport and disposal can be found in the current safety data sheet (SDS, SDS, MSDS). This flux is very versatile. There are good results for manual, wave and selective soldering as well as for cable assembly / wire tinning. The general rule of applying fluxes applied in principle as low as possible also applies to this product.
Sprayfluxing: If possible, try at first a quantity of 30 – 40 ml/min. and observe the distribution of the flux. After that, correct the quantity. Air pressure: 18 – 20 l/min.
Preheating: Entering the solder wave, the temperature on the topside of the pasteboards should be 80 – 110 °C, dependent on type of boards, layout etc. In case of using lead-free solders, preheating temperatures of 100 – 130 °C on the topsides are possible.
